CommLink After Successful session
Options :: Setup :: Start Up :: Wait :: Command Line :: Return Codes

“After Successful Session” events are executed when the Communications Link program ends if the session executed successfully.

The “Set Resource to” drop down box is used to enter or select the resource the kernel will be set to use if the session was successful. This drop down list contains the resource entries that currently exist on the client machine where setup is being run. To select a resource just highlight it in the list. If you wish you can enter the name of the resource to use. If you enter a name that does not exists on the client machine the current resource will be used. If you do not wish to change the resource the client is using just leave the field blank.

You can also enter a number for a resource. If the client has multiple resources assigned you can use the first assigned resource by entering a 0. This allows you to select resources based on a number and not the name. If you enter a number less than 0 or greater than the number of available resource the current resource will be used.

If a resource is specified the resource will be changed even if you choose to unload the kernel.

If you wish to leave the Kernel loaded after a successful session select the “Leave Kernel Loaded” option. Leaving the kernel loaded using an ASYNC resource will cause the COMM port to be in use.

After a successful session you can optionally execute a program or batch file. To execute a program just select the “Execute” option and enter the program you wish to execute. You can also click the browse button to select the executable. CommLink does not wait on the executable to complete.

Options :: Setup :: Start Up :: Wait :: Command Line :: Return Codes

RemoteWare® is a registered trademark of XcelleNet Inc. These products are not endorsed or supported by XcelleNet.